Fasteners, clips and seals are among the cheapest parts in a vehicle and among the most likely to stop a line. They’re used in huge numbers, they look alike, and nobody wants to count them by hand.

Why they're hard to manage

  • Thousands of pieces per bin.
  • Many similar part numbers.
  • High, variable consumption.
  • Low unit cost, so they get little attention until they run out.

Counting by weight

Weight-based counting suits these parts well: they are small and consistent in weight, and stored one part number per bin. A load cell under each bin measures the total weight, and the system calculates the quantity from the unit weight.

Good practice

  • One part number per bin for reliable counts.
  • Set the unit weight from a sample of the actual part.
  • Reorder points based on usage during the refill lead time.
  • Separate look-alike parts into clearly labelled bins.

Results

  • Live counts at every station.
  • Automatic refill signals.
  • Consumption data by station and shift.
  • Less time spent counting low-value parts.

See Smart Shelf & Weighing Bins and How Do Load Cells Work?.